The 1361X10N Transformer/X-10 Interface contained in this kit is
used in place of the standard system transformer for the purpose of controlling
X-10 devices from an alarm control panel. It is a replacement for the 4300
transformer, which is no longer available.
This installation kit contains:
(1) 1361X10N Transformer/X-10 Interface
(1) SA4120XM-1 Trigger Cable (Refer to Figure 1 for where-used
information)
(1) SA4142TR Trigger Cable (Refer to Figures 2 and 3 for
where-used information)
Install the 1361X10N as follows:

1. Wire as shown for the applicable control panel, using the
specified cable. See Installation And Setup Guide Above.
2. Plug the trigger cable into the trigger connector on the
control.
3. Plug the 1361X10N into an AC wall outlet.
4. Program the alarm panel as required for output device
control.