X-10 PLW01 Pro Wireless Light Switch With Dimming For Single Light Circuits
Description:
Upgrades your existing standard single pole wall switches.
For automation of indoor/outdoor lights including front porch-patio-Hallway-and
stairway lights.
Features:
Rated at 500W (incandescent).
Dimmable through X10 controllers.
The Wall Dimmer Module is designed to control incandescent loads with a
rating of between 40W
and 500W. Lamps rated below 40W may flicker or operate erratically. A
pushbutton is provided for
local on/off control. A power cut-off switch located directly below the
local on/off pushbutton is
provided for bulb changing. Both switches should line up for normal
operation.
Note: Wall Dimmer Modules must not be used to control appliances or
fluorescent lamps.
Manual push button control allows on/off. Dimming is performed only by
X-10 PRO commands.
The red dial is House Code (A-P), the black dial is Unit Code (1-16).
Installing the Wall Dimmer Module
• Disconnect power at the circuit breaker.
• Remove switch plate and unscrew existing switch from its box.
• Disconnect the wiring to the existing switch.
• Connect the blue wire of the Wall Dimmer Module to Live, the black
wire to Switched live (load)
using the wire nuts provided. Refer to the diagram above.
• Set the House Code dial to the same letter set on the controller or
Security Console. The House
Code for monitored security console is downloaded by the security
installation firm. The default
House Code is 'A' when using the PRO2000.
• For normal lighting control, set the Unit Code dial to an unused
code which can be controlled
from the controller or an RF remote such as the Security Remote, PSR01
(switches 1-4 control
Unit Codes 1-4).
• To use as the security light, set the Unit Code to the match the
Unit Code of the security
console. The Unit Code for monitored security consoles is downloaded by
the security
installation firm. The default Unit Code is '13' when using the PRO2000.
Note: The security light is the light which is flashed on/off during
an alarm and is controlled by
the security LIGHT ON and LIGHT OFF buttons on the console, keychain and
security
| 
