|
|
Ademco 998MX V-Plex 50' X 50' Motion
|
Complete Description Below:
Ordering And Information Above.
|
|
|
Ademco 998MX 50 X 50 Foot Multiplex PIR with Lookdown - 50' x 50' coverage
- Built-in Remote Point Module
- Both DIP switch and serial number addressing
- EZ-Mount features for fast installation
- Includes additional long range and pet alley lenses
- Horizontal and vertical pattern adjustment
- Automatic temperature compensation
- Extremely low current
- Tamper
- 6 year over-the-counter warranty
It makes sense to use ADEMCO's 998MX multiplex motion detector. Notonly is it smarter than ever, but it provides the opportunity to reduce your overallinstallation costs! Whether it's a commercial or residential installation, the 998MXoffers you the following benefits: - Point ID identifies the exact location of the intruder with either a DIP Switch Address or a Serial Number Address as distinctive as a fingerprint. And with the built-in Remote Point Module, the cost is less than a separate module and sensor.
- ADEMCO's patented Global Polling technology senses alarms up to up to 8 times faster than conventional multiplex.
- ADEMCO's unique 2-wire multiplex reduces installation costs over conventional 4-wire hardwire and multiplex approaches:
-- Wire cost is reduced and less than half the number of connections are necessary
-- No more need to home run wiring
-- Each sensor draws super low current, reducing power & battery requirements on large installations while allowing for longer wire runs or smaller gauge wire PIR Patterns ,Ordering Information | Detection Method Coverage - Standard Wide Angle Lens - 50' x 50' (15m x 15m), 90º
Long Range Lens - 100' x 10' (30m x 3m)
Pet Alley Lens (998 only) - 50' x 70' (15m x 21m), 100º Detection Pattern - Standard Lens: 18 zones (9 long range, 5 intermediate, and 4 short range)
- Long Range: 5 zones, (1 long range, 2 intermediate, 2 short range)
- Pet Alley: 12 zones Detector provides single downward-looking zone with all lenses (downward-looking window must be masked when using pet alley lens)
Pulse Count - Installer-selectable, 1-, 2-, 3-event
Detectable Walk Rate - 0.5-5 ft/sec (0.15-1.5m/sec)
Mounting Indicators - Red LED with enable/disable switch
Input Voltage - 8-11V peak to peak at polling loop terminals
Current - 1 mA (LED disabled) 3 mA (alarm, LED enabled)
Standby - Power source should be capable of at least 4 hours of battery standby
Operating Temp - 14º to 122ºF (-10º to 50ºC)
Operating Humidity - Up to 95% RH (max.), non-condensing
Dimensions - 2-5/8 W x 4-3/8 H x 2 D
(67mm x 111mm x 51mm) Accessories: - 998SB: Swivel bracket for 998
PIR Patterns Standard Lens | Pet Alley Lens | Long Range Lense |  |  |  | |
|
|
|
|
| 
