New Page 1X-10 PHRO4 2 Channel Keychain Remote
Turn your house lights on and off from the safety of your car!
X10's powerful, sleek and thin design is exactly what ourcustomers have asked for!
It has dual on/off buttons to remotely control your X10Lamp Modules, Appliance Modules, and Wall Switch Modules.
It even has the ability to dim and brighten your lights,even if they didn't before
The PHR04 Wireless RF Keychain Remote works with the X-10 PRO BaseTransceiver (PAT01) or any
X-10 PRO Security Base (PRO2000) to let you turn on/off two sequentiallycoded X-10 PRO Modules and
brighten/dim lights connected to Lamp Modules and Wall Switch Modules.
Setting up the Remote:
In the default state (after first fitting the battery) the PHR04 is set toHousecode A. The first (top) two
ON-OFF buttons control modules set to Unit Code 1. The second (middle) twobuttons control A2.
1. Plug in an X-10 PRO Transceiver (PAT01 or Security Console, soldseparately).
2. To turn on or off X-10 PRO Modules set to Unit Code 1 (on Housecode A)press the first (top) ON
or OFF button. To turn on or off X-10 Modules set to Unit Code 2 (onHousecode A) press the second
(bottom) ON or OFF button. To brighten or dim Lamp Modules or Wall SwitchModules press the
number button first, then press Bright or Dim button. If you want tocontrol Modules 1 and 2 on
Housecode A.
To change the Housecode:
• Press and hold the first (top)
ON button. The red LED blinks once. 3seconds later, the LED blinks thecurrent setting: 1 blink for Housecode A, 2 blinks for B..... 16 blinksfor P.
• Release the first (top)
ONbutton.• Press and release the first (top)
ON button the appropriate number oftimes for the Housecode youwant to set. Once for A, twice for B, etc. The LED blinks for each press.IMPORTANT: Hold the button
on your last press. 3 seconds later, the red LED blinks back the newsetting, (i.e. 3 blinks for Housecode
C). If you do not follow this programming sequence, the LED will stay onfor 1 second and your existing
setting will not be changed.
To change the Unit Code for the first (top) two buttons
(the second pair of buttons are alwaysone Unit Code # higher than the first pair, i.e. if you set the firstbutton to 6, the second button controls
7, etc.).
• Press and hold the top OFFbutton. The red LED blinks once. 3 seconds later,the LED blinks the current
setting: 1 blink for Unit Code 1, 2 blinks for 2, 16 blinks for 16.
• Release the top OFF button.
• Press and release the top OFFbutton the appropriate number of times for the UnitCode you want.
IMPORTANT: Hold the button on your last press. 3 seconds later new codeblinks back. If you do not
follow this programming sequence, the LED will stay on for 1 second andyour existing setting will
not be changed.
To change the battery: Pry the unitapart and fit a CR2025 Lithium 3V battery. Observe polarity.
Note: As with all RF transmitter devices; electrical fields, metal doorsor door/window frames and appliances can
cause interference that can decrease the strength of the transmittedsignal. Re-orienting the transmitter or
receiver console may increase your ability to send and receive thenecessary signals.
| 
