X-10 PA011 SuperSocket - Wall ReceptacleModule
Control you lights or appliances from across the room or the other sideof the house.
- Get the clean, finished look with SuperSocket!
- Appliance Module already built in!
X10 control on top, bottom outlet is always live! In areasof your house that have high visibility, use X10 Wall Receptacles for a clean, finishedlook.
The control components are built-in, so Lamp Modules arenot necessary.
Features a controlled outlet at the top of the receptacle,the lower outlet is not controlled.
Both outlets are rated at 15 amps.
Responds to ON/OFF and ALL UNITS OFF, but not to ALL LIGHTSON or DIM/BRIGHT commands.
Controlled devices may still be turned off and on withtheir own switches.
The Wall Receptacle Module is designed to control unrestricted loads up to15Amp. It provides
two outlets, one X-10 controlled (upper) and one which is always on(lower). A trim plate is
included to complete the installation.
• Disconnect power at the circuit breaker.
• Remove the existing wall plate and unscrew the receptacle from itsbox.
• Disconnect the wiring to the existing receptacle.
• Connect the black wire of the Wall Receptacle Module to Live, thewhite wire to Neutral and the
green wire to ground (or the wall box) using the wire nuts provided. Referto the diagram
above.
• Refit the Wall Receptacle Module in the wall box and finish offwith the trim plate provided.
• Set the House Code dial to the same letter set on the controller orSecurity Console. The House
Code for monitored security consoles is downloaded by the securityinstallation firm. The
default House Code is 'A', when used with the X-10 PRO2000.
• Set the Unit Code dial to an unused code which can be controlledfrom the controller or an RF
remote such as the Security Remote, PSR01, (switches 1-4 control UnitCodes 1-4 When used
with the X-10 PRO2000).
| 
