The XPSS Momentary Slave Switch is designed to operate in conjuction withthe
XPD3, XPDI3, and the XPS3 Wall Switches. The XPSS Slave Switch is not aload
bearing switch, it simply transmits signal over the dedicated travellerwires to the
Master Switch for auxillary control. The LED on the Slave Switch is nonfunctional
and there are no House and Unit codes to set.
3-Way Application
• When creating a three-way application, simply connect the 120VAC(referred to as
Line or Live) to the XPSS. Line can come from either wall box in theapplication and
connect to the Traveller, carrying Line to the other location.
• Connect the Traveller that carries the Control from the Master tothe Switch position
on the XPSS Slave.
4-Way Applications
• When creating a four-way application, simply parallel another XPSSacross the
same two travellers from the first Slave location. Connect wires fromSwitch to
Switch and Live to Live, using the feed thru screw terminals.
Note: Typically the center Switch will have 4 wires, two fromthe master and two
from the last slave. Place the two wires carrying Line in the socketmarked Live on
the XPSS. Then place the other two wires carrying Control to the Switchposition on
the XPSS.
| 
