New Page 1X-10 XPCP Single Gang Phase Coupler.
Used When Your X-10 Signal Is Not Working On Half The Electric Of Your Building.
Installs in any single gang electrical box to couple both phases of the 220V circuit.
Most residences have 2 phase electric systems. 3 Phase is usually commercial orindustrial. Your circuit breaker panel has 2 120 volt feeds from the electric company. Allyou have to do is to take a 14/3 and run it from your electric panel to a single gang boxthat you can install yourself next to or near your electric panel. Then you would tie inthe neutral, Then 1 phase lets say black wire to 1 breaker (you can double up on any 15amp breaker with what is already there) then run the second wire lets say red wire to asecond breaker on the other phase as above.
When you open your circuit breaker panel you will see 2 feeds at top. Then you will seethe 2 phases feed down staggering every level.
EXAMPLE: Tie in--- Red wire to breaker 2 --- Black wire to breaker 4 and White wire toneutral. You now have both phases connected to X-10.
NOTE:
- Do Not Tie Into TWIN Breakers On The Same Phase It Will Not Work. IE: 2 Switches on 1 Breaker In One Slot.
- DO NOT TIE ACROSS A 240 VOLT Double Breaker, As The Load, Surge Might Damage The XPCP Unit.
| 
